Professional egg tray machine manufacturer | egg tray production line

Language

12 Tips to Operate the Egg Crate Making Machine Correctly

The unfamiliarity with the equipment performance configuration parameters and specific operating procedures, and the non-standard operation of the egg crate making machine often causes the malfunction of machine. Therefore, in order to reduce the probability of failure of the egg crate making machine and ensure the safety of operators,  please strictly follow the operation standards and specifications of the equipment when operating the egg crate making machine. Whoever operates and uses the egg crate making machine must undergo professional technical training before operating the equipment.
The following are 12 tips of egg crate making machine operating standards and specifications:
1. Strictly abide by the relevant safety operation procedures, and wear labor protection equipment as required;
2. Before starting the egg crate making machine, the upper and lower molds should be cleaned and wiped clean;
3. Check whether there is any foreign matter on the support frame, stopper frame and slider, if there is any foreign matter, it should be cleaned up;
4. According to the thickness of the folded sheet, select the appropriate die, the die size is generally equal to or greater than 8 times the thickness of the sheet;
5. The bending force of the workpiece can be obtained from the bending force number of the sheet or the calculation formula of the bending force, and the bending force of the workpiece shall not be greater than 1000KN6. When bending narrow sheets, the working pressure of the system should be appropriately reduced to avoid damage to the mold;

egg crate making machine
egg crate making machine for sale

7. When adjusting the stroke of the slider, it should be ensured that the adjustment amount is less than 100, so as not to damage the machine;
8. Before bending, the gap between the upper and lower molds should be adjusted uniformly;
9. When bending, do not put your hands between the molds, and do not support long and narrow materials by hand. Only one piece of material can be bent at a time, and not many sections can be bent at the same time. Check the oil level of the fuel tank, start the oil pump to check whether the hydraulic pipeline and the oil pump are abnormal;
10. The bending sheet should be placed in the middle of the mold. The machine should not be loaded on one side, so as not to affect the workpiece and machine accuracy. If some workpieces really need to work on one side, the load should not be greater than 250KN, and both sides must be bent at the same time;
11. Check the oil level of the oil tank, start the oil pump to check whether the hydraulic pipeline and oil pump are abnormal;
12. Immediately shut down when an abnormality occurs, check the cause and eliminate it in time;
In order to reduce the unsafe factors during the operation of the egg crate making machine and avoid various failures of the equipment, the operator of the egg crate making machine must carefully read the instructions to master the correct operation method of the egg crate making machine. It is necessary to formulate the operating standards and specification requirements of the egg crate making machine, and operate and use them in strict accordance with its specification requirements.

WhatsApp Message
Top